Cleanse Plus is the most effective two-step process for exfoliating and cleansing the scalp before hair system application.

Special pump on Liters bottle indicates the amount of mL distributed per pump. 5mL is the recommended amount per service.

Instructions: Wearing gloves, apply 1 teaspoon of Step 1: Cleansing Scrub to adhesive area on scalp. Massage in a circular motion for at least 30 seconds or until adhesive has broken down. Before rinsing, continue with Step 2: Deep Clean Shampoo. After applying Step 1: Cleansing Scrub, using gloves, massage a teaspoon of Deep Clean Shampoo onto the scalp for at least 30 seconds. Rinse, remove excess water, and repeat if necessary.

Caution: Avoid eye contact. Do not swallow. Keep container closed when not in use. Store and handle in accordance with good industrial practices. This material is not considered hazardous to health under normal conditions of use.

First Aid: If eye contact occurs, immediately flush eyes with water and continue washing for at least 15 minutes; separating eyelids with fingers and rolling eyes in circular motion. Obtain medical attention if problem persists. If wearing contact lenses, obtain immediate medical attention. If swallowed, DO NOT INDUCE VOMITING, and seek prompt medical attention. For further health information, contact a poison control center.

Step 1 Ingredients:

Capohol, cocamide, crushed walnut, menthol, preservative (Nipastat), H2O2, colour, mixture of mineral salts. Zea mays Cob meal, diopropylene glycol n-Butyl, ether (DPnB), Laureth-6, D-Limone, TEA, Polyacrylic Acid, Simmondsia Chinesis Seed Oil (Jojoba), aloe barbadensis leaf extract, lanolin, dehydroacetic acid, benzyl alcohol, perfume, citronellol, hexyl cinnamal, butylphenyl methylpropional, CI 77891

Step 2 Ingredients:

Aqua, sodium laureth sulfate, cocamidopropyl betaine, citric acid, parfum, 2-bromo-2-nitropropane-1.3-diol, CI:15985

Get Full Access!

Page not found